EasyManua.ls Logo

Husqvarna R 216 - Page 27

Husqvarna R 216
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem Cause
The engine apparently has no
power
The air filter is clogged. See
To clean and change the air filter on page 18
.
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle cable is incorrectly adjusted.
The transmission does not have
sufficient power
The transmission cold air intake or the cooling fins are blocked.
The fan on the transmission is damaged.
There is no oil in the transmission or the oil level is too low. See
To do a check
of the transmission oil level on page 25
.
The battery does not charge The battery is defective. See
Battery safety on page 9
.
The connection at the cable connectors on the battery terminals is bad. See
Bat-
tery safety on page 9
.
There is vibration in the product The blades are loose. See
To examine the blades on page 24
.
One or more of the blades are unbalanced. See
To examine the blades on page
24
.
The engine is loose.
The cutting result is unsatisfacto-
ry
The blades are blunt. See
To examine the blades on page 24
.
The grass is long or wet. See
To get a good cutting result on page 14
.
The cutting deck is skew.
There is grass blockage in the cutting deck. See
To clean the product on page
16
.
The tire pressure is different on the right and left sides. See
Tire pressure on
page 21
.
The product is operated at a too high speed. See
To get a good cutting result on
page 14
.
The engine speed is too low. See
To get a good cutting result on page 14
.
The drive belt slips.
Transportation, storage and disposal
Transportation
The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
Use an approved trailer for transportation of the
product.
Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
WARNING: The parking brake is not
sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
854 - 003 - 14.11.2018 27

Related product manuals