Husqvarna R 318X - Examining and Replacing Spark Plug; Charging the Battery

9.1.1.7 To remove the right footrest plate
1. Turn the knob on the reverse pedal and remove the
knob.
2. Remove the 4 screws and remove the footrest plate.
9.1.1.8 To remove the right side cover
1. Remove the right footrest plate. Refer to To remove
the right footrest plate on page 23 .
Note: 2 of the screws of the footrest plate also hold
the right side cover.
2. Remove the 2 screws and remove the right side
cover.
9.1.1.9 To remove the transmission cover
• Remove the 2 screws and remove the transmission
cover.
9.1.1.10 To remove the frame tunnel cover
1. Remove the 2 screws (A).
A
C
B
2. Push the frame tunnel cover rearward (B) and lift the
front end of the frame tunnel cover (C).
9.1.2 Throttle cable
9.1.2.1 To do a check of the throttle cable
Make sure that the engine speed changes when the
throttle is changed. Do a check that the engine gets the
correct speed at full throttle. See
Technical data on page
66
855 - 002 - 28.03.2019 Repair instructions - 23