identify the hoses with the part numbers on the hoses if
the marks are damaged.
1 Red
2 Green
3 Black
9.5.8 To attach the hydraulic hoses
Tighten the couplings with a 25 Nm torque.
1. Connect the rear couplings on all the hoses to make
sure that they are in the correct position in the
package. Connect green to the front connection on
the hydrostatic transmission. Connect red to the rear
and black to the tank.
2. Keep the green and black hoses together.
3. Start winding the hose protection 115±20 mm from
the center of the green hose connection on the
hydrostatic transmission. Put the end of the hose
protection between the 2 hoses and wind the
protection 4-5 turns.
4. Put the red hose to the left side of the package.
5. Wind the hose protection around all 3 hoses until
80-100 mm from the sleeve on the black hose.
6. Connect the front end of the hoses to their pipes.
9.5.9 To replace the oil in the front and rear
hydrostatic transmissions
WARNING: Transmission oil is dangerous to
your skin. Clean spills with soap and water.
WARNING: Used oil and filters are dangerous
to the environment. Discard used chemicals at
an applicable disposal location.
Obey the instructions in
To keep the hydraulic system
clean on page 41
.
1. Put a container below the drain plugs.
2. Open the 2 plugs to drain the front hydrostatic
transmission.
3. Open the 2 plugs to drain the rear hydrostatic
transmission.
4. Replace the hydrostatic transmission filter. See
To
replace the hydrostatic transmission filter on page
42
.
5. Attach the drain plugs.
6. Fill the transmission oil tank with oil.
7. Bleed the hydrostatic transmission. See
To bleed
the drive system on page 43
.
8. Do a test of the product and fill with oil to the correct
level in the transmission oil tank.
9.5.10 To replace the hydrostatic transmission filter
WARNING: Transmission oil is dangerous to
your skin. Clean spills with soap and water.
WARNING: Used oil and filters are dangerous
to the environment. Discard used chemicals at
an applicable disposal location.
CAUTION: Do not tighten the filter lid to much.
The filter lid is made of plastic.
42 - Repair instructions 855 - 002 - 28.03.2019
To Next Page
Loading...
