18 – English
Maintenance
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.
!
WARNING! No service procedures must be conducted on the engine or cutting unit unless:
The engine is switched off.
The parking brake is applied.
The ignition key is removed.
The cutting unit is disengaged.
The ignition cables are removed from the plugs.
Maintenance
Daily
maintenance
Weekly
maintenance
At least
once a year
Maintenance interval in
hours
25 50 100 200
Cleaning X
Clean the cutting deck, under the belt covers and
under the cutting deck.
O
Clean transmission air intake O
Clean thoroughly around transmission O
Clean thoroughly around engine O
Clean around the silencer O
Clean the air filter. X X X
Clean the engine’s and transmission’s cooling fins
2,6)
O O O
Clean inside frame tunnel X
Check/adjust cutting height setting X X X X
Check/adjust front and rear wheel rotation speed
6,8)
O O O O
Checking the engine’s cooling air intake X
Check the cooling fins on the hydrostatic
transmission
O O O
Checking and adjusting the choke wire X X X
Check the engine’s oil level X
Check the fuel pump air filter X
Check for damage to wire guide at articulated joint O
Check the steering wires X
Check the battery X
Check the safety system X
Check nuts and screws O
Check for fuel and oil leakage. O
Check the cutters in the cutting deck X X
Checking the tyre pressure X X X X
Check/adjust parking brake X X X X
Check the V-belts O O O O
Check the oil level in the transmission, top up if
necessary.
O
Checking and adjusting of throttle wire X X X
Check the fuel hose. Replace if necessary .
6)
O
Change the oil in the gearbox
7)
O O O
Change the engine oil
3, 4)
X X
To Next Page
Loading...
