Need help?Do you have a question about the Husqvarna R 422Ts and is the answer not in the manual?
General| Cylinders | 2 |
|---|---|
| Oil Filter | Yes |
| Battery Type | Lead-Acid |
| Battery Voltage | 12 V |
| Cutting Deck Material | Steel |
| Blades | 3 |
| Powder-Coated Cutting Deck | Yes |
| Transmission Type | Hydrostatic |
| Seat Material | Vinyl |
| Service Reminder | Yes |
| Cup Holder | Yes |
| Headlights | Yes |
| Sound Power Level, guaranteed (LWA) | 100 dB(A) |
| Power Output | 14.5 kW |
| Engine Cooling | Air |
| Fuel Type | Gasoline |
| Cutting Width | 107 cm |
| Cutting Methods | Rear Ejection |
| Blade Engagement | Electric |
| Tyre Dimension Front | 15 x 6.0-6 |
| Wheel Size (Front) | 15 inches |
| Wheel Size (Rear) | 18 inch |
| Seat Type | High-back |
| Hour Meter Type | Digital |
| Parking Brake, type | Mechanical |
| Cylinder Displacement | 656 cm³ |
| Cutting Height, min-max | 25-102 mm (1-4 inches) |
Detailed checks and adjustments before customer use.
Initial service checks and oil changes after initial usage.
Welcome message and overview of the operator's manual.
Guidelines for safe operation on roads and transport.
Instructions for towing and intended machine use.
Information on customer support and service.
Visual guide to all warning and operational symbols used.
Identification and numbering of all machine controls and features.
Essential safety warnings and operational precautions.
Critical safety advice for operating on inclines.
Precautions to protect children from hazards.
Guidelines for safely transporting the machine.
Introduction to the machine's design and its engine.
Explanation of key controls like throttle, choke, and speed limiter.
Operation of cutting unit and hydraulic lift mechanisms.
Instructions for fueling, lights, power outlets, and clutch controls.
Advice for optimal mowing and engine starting procedures.
Procedure for jump-starting the machine.
How to operate the drive pedals and brakes safely.
Correct procedure for shutting down the engine.
Comprehensive list of maintenance tasks and intervals.
Procedures for cleaning the machine and removing covers.
Adjusting steering wires and parking brake.
Maintaining fuel filters, control cables, and spark plugs.
Checking air intake, ignition, and safety systems.
Checking tyre pressure and replacing drive belts.
Servicing, removing, and adjusting the cutting unit.
Replacing cutting unit belts and checking blades.
General advice and procedures for lubrication.
Lubricating cables, pedals, chains, and joints.
Lubricating seat runners and checking engine oil.
Procedures for changing oil filters and hydraulic oil.
Lubricating parking brake wire and checking transmission oil.
Diagnosing and resolving engine start or running issues.
Troubleshooting battery, vibration, and mowing problems.
Diagram identifying electrical and hydraulic system parts.
Maintenance and care for the hydraulic system.
Steps for preparing the machine for extended storage.
Advice on seasonal servicing and protective covers.
Detailed technical data for dimensions, engine, and transmission.
Cutting unit specifications and sound/vibration levels.
Manufacturer's declaration of compliance with EU directives.
To Next Page