4
–
English
Ser
vice journal
Pre-deliver
y service
1
Charge the battery for 4 hours at max. 3 amp.
2 Fit steering wheel, seat and any optional
equipment.
3 Check and adjust tyre pressure (60 Kpa, 0.6 bar,
9 PSI).
4 Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit
should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4
mm / 1/8” higher than front edge.
Adjust cutting unit height setting so that cutting
height limit is 5 mm / 3/16”
above the frame of the
unit at the lowest cutting height.
5 Check that the right amount of oil is in the engine.
6 Check that the right amount of oil is in the
tr
ansmission. (Not Rider 11).
7 Connect battery.
8 Fill with fuel and start engine.
9 Check that machine does not move in neutral.
10 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
Safety switch for the hydrostat pedals/neutral
position.
Check engine speed. See the Technical data
section.
11 Check the synchronisation between the front and
rear wheels
. (Rider 16 AWD) See the workshop
manual.
12 Tell customer about:
Needs and benefits of following the service
schedule
.
Servicing and the influence of this journal on the
second-hand v
alue of the machine.
Range of applications for BioClip.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems.
Cer
tified:
_________________________________________________________
Date, mileage, stamp, signature
After the first 8 hours
1
Change engine oil
2 Change the oil in the gearbox. (Only AWD-
machines)
3 Check the synchronisation between the front and
rear wheels
. (Only AWD-machines)
To Next Page
Loading...
