Husqvarna RZ4824F User Manual

25
OPERATION
Before Starting
1. Read the sections on Safety and Controls before
starting the machine.
2. Perform the daily maintenance before starting
(see Maintenance Schedule in the Maintenance
section).
3. Check that there is sufficient fuel in the fuel tank.
4. Adjust the seat to the desired position.
8058-024
Secure selected cutting height
5. Set the deck cutting height by inserting the lift pin
into the desired cut height. Resecure the lift pin
with the hairpin.
8058-023
Lengthways adjustment
The following conditions must be fulfilled before the
engine can be started:
• The blade switch must be pressed downward into
the disengaged position.
• The parking brake must be up into the activated
position.
• Both steering controls must be in the locked
(outer) neutral position.

Husqvarna RZ4824F Specifications

General

Engine Manufacturer	Kawasaki
Engine Power	24 hp
Cutting Width	48 inches
Cutting Height	1.5 - 4 inches
Fuel Capacity	3.5 gallons
Transmission Type	Hydrostatic
Blades	3
Deck Type	Fabricated
Turning Radius	Zero-Turn
Warranty	3 years