How to fix Husqvarna Vacuum Cleaner when the motor does not start?
If the Husqvarna Vacuum Cleaner motor doesn't start, it could be due to several reasons. First, ensure the product is properly connected to a power source. If it is, the power cord might be defective and needs replacement. Alternatively, the ON/OFF switch or the soft start unit could be defective, requiring replacement.
Why is the suction weak on my Husqvarna S 13 Vacuum Cleaner?
If your Husqvarna Vacuum Cleaner motor is running but the suction is weak, check these potential causes: the hose may be damaged and require replacement; the filter could be clogged, needing cleaning or replacement; the top cover might be loose and needs adjustment; there could be dirt on the lid at the bottom of the container, requiring cleaning; or the gaskets may be defective and need replacement.
What to do if Husqvarna S 13 has motor running but no suction?
If the motor of your Husqvarna Vacuum Cleaner is running but there's no suction, it might be due to a disconnected or clogged hose. Ensure the hose is properly connected. If it is, check for blockages and clean the hose. Also, make sure a dust bag is installed.
Why does my Husqvarna S 13 motor stop immediately after starting?
If the Husqvarna Vacuum Cleaner motor stops immediately after starting, it could be due to an incorrect fuse. Connect to the correct fuse. Alternatively, there may be a short circuit in a cable or the product, requiring servicing.
Why is dust blowing from the motor of my Husqvarna S 13 Vacuum Cleaner?
If dust is being blown from the motor of your Husqvarna Vacuum Cleaner, the filter system may be incorrectly assembled or damaged. Try adjusting or replacing the filters.
What to do if Husqvarna Dust Collector motor does not start?
If the motor of your Husqvarna Dust Collector doesn't start, there could be several reasons. First, ensure the machine is properly plugged in. If it is, the cable might be defective and require replacement. Alternatively, the switch or soft start may be defective, also requiring replacement.
Why Husqvarna Dust Collector motor runs but there is poor suction?
Poor suction in your Husqvarna Dust Collector, despite the motor running, can stem from several issues. Check for a hole in the hose and replace it if necessary. The filter might be clogged, requiring cleaning or replacement. Ensure the top cover is correctly adjusted and not loose. Also, inspect the flap for any dirt accumulation and clean it. Finally, defective gaskets can also cause poor suction, so replace any affected gaskets.
Why Husqvarna Dust Collector motor runs but there is not suction?
If the motor of your Husqvarna Dust Collector is running but there's no suction, it could be due to a few reasons. Make sure the hose is properly connected. If it is, check if the hose is blocked and clean it if necessary. Also, ensure that a dust collection bag is fitted to the system.
What to do if Husqvarna Dust Collector motor stops immediately after starting?
If your Husqvarna Dust Collector's motor stops immediately after starting, it might be due to an incorrect fuse. Ensure you are using the correct fuse. It could also indicate a shortcut in the cable or machine.
Why is dust blown from Husqvarna Dust Collector motor?
Dust being blown from the motor of your Husqvarna Dust Collector is likely due to a wrongly assembled or damaged filter system. Try adjusting or replacing the filters.
General| Model | S 13 |
|---|---|
| Category | Vacuum Cleaner |
| Power Source | Electric |
| Phases | 1 |
| Slurry capacity | 13 l |
| Dust Capacity | 13 l |
| Frequency | 60 Hz |
| Noise Level | 72 dB |
To Next Page
