What to do if Husqvarna Dust Collector motor does not start?
If the motor of your Husqvarna Dust Collector doesn't start, there could be several reasons. First, ensure the machine is properly plugged in. If it is, the cable might be defective and require replacement. Alternatively, the switch or soft start may be defective, also requiring replacement.
Why Husqvarna Dust Collector motor runs but there is poor suction?
Poor suction in your Husqvarna Dust Collector, despite the motor running, can stem from several issues. Check for a hole in the hose and replace it if necessary. The filter might be clogged, requiring cleaning or replacement. Ensure the top cover is correctly adjusted and not loose. Also, inspect the flap for any dirt accumulation and clean it. Finally, defective gaskets can also cause poor suction, so replace any affected gaskets.
Why Husqvarna Dust Collector motor runs but there is not suction?
If the motor of your Husqvarna Dust Collector is running but there's no suction, it could be due to a few reasons. Make sure the hose is properly connected. If it is, check if the hose is blocked and clean it if necessary. Also, ensure that a dust collection bag is fitted to the system.
What to do if Husqvarna Dust Collector motor stops immediately after starting?
If your Husqvarna Dust Collector's motor stops immediately after starting, it might be due to an incorrect fuse. Ensure you are using the correct fuse. It could also indicate a shortcut in the cable or machine.
General| Model | S 36 |
|---|---|
| Category | Vacuum Cleaner |
| Power Source | Electric |
| Power | 3.6 kW |
| Voltage | 220-240 V |
| Phases | 1 |
| Frequency | 50/60 Hz |
| Max Vacuum | 220 mbar |
| Number of Filters | 3 |
| Pre-filter Type | Conical |
| HEPA Filter | Yes |
| Filter Type | HEPA 13 |
| Dust Container Volume | 45 l |
| Dust Capacity | 20 L |
To Next Page
