7
ASSEMBLY
Fig. 4
ADJUST SEAT (See Fig. 4)
• Sit in seat.
• Lift up adjustment lever (A) and slide seat until a com-
fortable position is reached which allows you to press
clutch/brake pedal all the way down.
• Release lever to lock seat in position.
TO ASSEMBLE BAGGER (See Figs 5 - 8)
• Unfold bag and stand right side up.
• Uninstall carriage bolts (5/16-18 x 1.5) and nuts (1)
from the front of the top frame.
• Remove cross braces (6) from inside of bagger as-
sembly.
• Slide cross brace (6) onto pin (7) at the rear of the up-
per bagger frame and secure with retainer spring clip
(8).
• Slide cross brace (6) onto pin (9) at the front of the
bagger frame and secure with retainer spring clip (10).
• Repeat on opposite side.
• Remove clevis pin (11) and retainer spring (12) from
bagger handle (13).
1
1
2
4
53
3
• With bagger assembly on its side, feed front bagger
frame ends (2) through fabric loops at each side of
bagger.
• Reinstall carriage bolts and nuts (1) to connect front
frame to top frame, passing through bagger fabric (4).
Tighten securely.
CAUTION: Do not exceed 100 In-Lbs/11,2 Nm.
• Snap front bagger frame bottom (3) into snap feature
(5) at front of bagger bottom.
Fig. 5
Fig. 6
NOTE: You may now roll your tractor off the skid. Continue
using the instructions that follow to remove the tractor from
the skid.
WARNING: Before start ing, read, un der stand and fol-
low all in struc tions in the Op er a tion section of this man u al.
Ensure tractor is in a well-ventilated area. Ensure the area
in front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op er a tion
section for location and function of con trols)
• Raise attachment lift lever to its highest po si tion.
• Release parking brake by de press ing clutch/brake
ped al.
• Place freewheel control in "TRANS MIS SION DIS EN-
GAGED" position. (See “TO TRANS PORT” in the
Op er a tion section of this manual.)
• Roll tractor forward off skid.
Continue with the instructions that follow.
A
To Next Page
Loading...
