5
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.
ASSEMBLY
UNASSEMBLED PARTS
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton.
• Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels fl at.
• Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
Slope Sheet
Key(s)
Keys
(1) Quick
Connect
(1) Oil Drain Tube
Seat
(1) Seat
(3) Flat
Washer
(3) Bolt
Battery
(2) Hex Bolts
(2) Nut Keps
(1) Knob
(1) Cup
Washer
*Installed by Dealer
*Brush Guard Kit
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) 5/16" wrench Utility knife
(2) 7/16" wrenches Tire pressure gauge
(2) 1/2" wrenches Pliers
(2) 9/16" wrench
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
To Next Page
Loading...
