Frequently Asked Questions
Does my HUSQVARNA VIKING
®
PLATINUM
™
MN 1000 embroidery machine need any special
maintenance?
Your HUSQVARNA VIKING
®
PLATINUM
™
MN 1000 embroidery machine is easy to care for but it
does need regular lubrication to the rotary hook, lever arms, and machine head. The rotary hook should be
lubricated with two to three drops of standard sewing machine oil every four hours when in constant use,
or prior to turning on the machine. The ten lever arms should be lubricated with sewing machine oil every
week of continuous use. The machine head rail should be lubricated every week, and the black metal bar on
the machine head should be lubricated with white lithium grease every five months. See your owners manual
for more instructions.
Error: Main Axis not at 100 degrees
The machine needs to be at 100 degrees for normal operations. A main axis error is the machine’s way of
letting you know that the sensor is not aligned. To resolve this, select the 100 degree icon on your control
panel. If a “No needle” error is displayed, then the needle is not being detected over the working area. To
correct this, turn off the machine. Then, locate the degree wheel knob in the back of your machine and
manually align it to 100 degrees. Turn the machine back on, and the machine will automatically find a needle
position. After everything has finished loading, press the 100 degree icon on the panel once more. If there
are no more error messages displayed, the machine is functional.
Note: On rare occasions, this process may need to be repeated before the sensors reset. Simply go through the procedure until the
needle position is recognized.
Setup/Operation
To Next Page
Need help?
General
