Need help?Do you have a question about the Husqvarna VIKING E10 and is the answer not in the manual?
General| Buttonhole | 1-step |
|---|---|
| Needle Positions | Variable |
| Presser Foot Pressure | Adjustable |
| Free Arm | Yes |
| Built-in Needle Threader | No |
| Type | Mechanical |
| Bobbin Type | Front-loading |
| Adjustable Stitch Length | Yes |
| Adjustable Stitch Width | Yes |
| Reverse Function | Yes |
| Stitches | 21 |
| Buttonhole Styles | 1 |
| Stitch Length | Up to 4 mm |
| Stitch Width | Up to 5 mm |
| Presser Feet | Buttonhole Foot |
| Included Accessories | Needles, Bobbins, Screwdriver |
| Stitch Options | Utility, Decorative |
Instructions for removing the machine's face cover.
Instructions for removing the free arm cover.
Instructions for removing the base cover.
Instructions for removing the back cover of the sewing machine.
Instructions for removing the front cover of the sewing machine.
Check and adjust the lower thread tension for proper stitch formation.
Check and adjust the upper thread tension for correct stitch interlacing.
Adjust the presser bar height and ensure proper alignment with the needle plate.
Adjust the needle's center position during the feeding process.
Adjust the vertical height of the needle bar.
Adjust needle swing in zigzag and check worm gear play.
Adjust needle's center position for straight stitch sewing.
Adjust the needle's position for zigzag stitching.
Check and adjust the axial play of the arm shaft.
Adjust the clearance between the needle and the hook.
Adjust play between shuttle driver shaft gear and lower shaft gear.
Adjust the distance between shuttle driver shaft gear and lower shaft gear.
Set the correct timing between the needle and the hook.
Synchronize feed lifting with the needle position.
Adjust the height of the feed dog.
Adjust front and back clearance between feed dog and needle plate.
Adjust side clearance between feed dog and needle plate.
Adjust the balance for stretch stitch sewing.
Adjust the cutting space between buttonhole columns.
Adjust feed balance for buttonhole columns.
Ensure zero feeding for buttonhole bar tacks.
Adjust motor belt tension for optimal operation.
Adjust bobbin winding for even filling and correct amount.
To Next Page