Husqvarna Viking Platinum Q 165 User Manual

28 | powerquilter 1650 Quilng Machine User’s Guide
Quilting With the Platinum Q|165
Preparing to Quilt
1. Make sure your machine has been cleaned, oiled, has a new needle, and that the tracks on the frame
are free from threads or other debris. If the machine isn’t already plugged in, plug it in now.
2. Select your thread and wind one or more bobbins.
3. Turn on the power switch at the back of the machine.
4. Set your bobbin tension and thread your machine.
5. Aer loading your quilt, use a scrap of fabric along the edge of the quilt backing and bang to test the
top tension. Make adjustments to the top tension as needed.
Using the Handlebar Buons
To bring bobbin thread to the top of the quilt
1. Aer the machine is threaded, move the machine over the quilt to your
starng locaon.
1.09”
1.09”
UP
DOWN
SPEED
DOWN
2. While rmly holding the tail of the needle thread, press the needle up/
down buon twice, causing the needle to go down through the quilt
sandwich and then back to the up posion. Or press and hold the up/down
buon unl the needle does a full revoluon; then release the buon.
3. Move the machine four to six inches while holding the needle thread in place. The bobbin thread will
pull up through to the top of the quilt.
4. Grasp the bobbin thread loop and pull it to the desired length. Reposion the needle to the starng
locaon, e o the threads by quilng a few stches in place. Then begin quilng.
To start or stop quilng
• Start or stop the machine at any me by pressing the Start/Stop buon
on the handlebars.
1.09”
1.09”
SPEED
UP
START
STOP

Husqvarna Viking Platinum Q 165 Specifications

General

Brand	Husqvarna
Model	Viking Platinum Q 165
Category	Sewing Machine
Language	English