Husqvarna Z 242F - Troubleshooting

47
CONTROLES
Este manual del operador corresponde al
cortacésped Zero Turn de Husqvarna. El
FRUWDFpVSHGHVWiHTXLSDGRFRQXQPRWRUGH
YiOYXODVXSHULRUGHFXDWURWLHPSRV
La transmisión del motor se hace mediante
ERPEDVKLGUiXOLFDVDFFLRQDGDVSRUFRUUHD
Utilizando los controles de la dirección izquierdo
y derecho, el caudal regula el sentido de marcha
y la velocidad.
1. Palancas de dirección/freno
2. Ajuste de la alineación
3. Elevación del equipo
4. Fusibles
5. 9DULOODMHVGHGHULYDFLyQ
6. 9iOYXODGHFRUWHGHFRPEXVWLEOH
7. Depósito de combustible
8. Estrangulador
9. Control del acelerador
10. Medidor de servicio
11. Interruptor de encendido
12. Interruptor de cuchilla
1
2
10
11
12
3
4
6
7
8
9
5
Engine will not start
Blade switch is engaged
Steering controls are not locked in the outer
position
Dead battery
Contamination in the carburetor or fuel line
)XHOVXSSO\VKXWRႇYDOYHLVFORVHGRULQWKH
wrong position
&ORJJHGIXHO¿OWHURUIXHOOLQH
Ignition system faulty
Starter does not turn the engine over
Dead battery
Battery terminal cable contacts are defective
Blown fuse
Fault in the starter safety circuit. See Safety
System in the Maintenance Section
Engine runs rough
Faulty carburetor
&ORJJHGIXHO¿OWHURUMHW
Throttle lever in the Cold Weather starting
position
Clogged ventilation valve on the fuel cap
Fuel tank almost empty
Fouled spark plugs
Rich fuel mixture or fuel-air mixture
Wrong fuel type
Water in fuel
&ORJJHGDLU¿OWHU
Engine seems weak
&ORJJHGDLU¿OWHU
Fouled spark plugs
Carburetor incorrectly adjusted
Air trapped in the hydraulic system
Machine vibrates
Blades are loose
Blades are incorrectly balanced
Engine is loose
Engine overheats
&ORJJHGDLULQWDNHRUFRROLQJ¿QV
Engine overloaded
Inadequate ventilation around engine
Defective engine speed regulator
Too little or no oil in the engine
Contamination in the fuel line
Fouled spark plugs
Battery not charging
Battery terminal cable contacts are defective
Charging lead is disconnected
Mower moves slowly, unevenly, or not at all
Bypass linkages are engaged
7UDQVPLVVLRQGULYHEHOWLVVODFNRURႇ
Air trapped in the hydraulic system
Mower deck not engaging
Drive belt for the mower deck is loose
Electromagnetic coupling contact is loose
Blade switch is faulty or loose from cable
contact
Blown fuse
Transaxle leaks oil
Damaged seals, housing or gaskets
Air trapped in the hydraulic system
Uneven mowing results
Unequal air pressures in the tires
Bent blades
Suspension for the mower deck is uneven
Blades are dull
Driving speed is too high
Grass is too long
Grass collected below the mower deck
30
TROUBLESHOOTING
Problem / Cause