What to do if Husqvarna AUTOMOWER 310 Lawn Mower has a temporary battery problem because of battery temp sensor?
If your Husqvarna Lawn Mower has a temporary battery problem due to a defective battery temperature sensor, change the battery.
Why is my Husqvarna AUTOMOWER 310 Lawn Mower charging station showing a red flashing light?
A red flashing light on your Husqvarna Lawn Mower charging station indicates an interruption in the charging station’s antenna. Unfortunately, I cannot provide specific troubleshooting steps for this issue. Please contact your local Husqvarna representative for assistance.
Why does my Husqvarna Lawn Mower have a battery problem?
If your Husqvarna Lawn Mower displays 'Battery problem', it could be due to several reasons. The battery might not be connected properly, so dismantle the mower and check the battery connection. The battery might be faulty, so check the connection again. Ensure you are using only original batteries from Husqvarna. The main circuit board could also be faulty.
Why does my Husqvarna AUTOMOWER 310 Lawn Mower have no drive?
If your Husqvarna Lawn Mower has 'No drive', it might be caught in something. Free the mower and fix the cause. If it is due to wet grass, wait until the lawn dries. The working area might have a steep slope; isolate slopes steeper than 40%. If the guide wire is on a slope, ensure it's laid at an angle across the slope.
How to find breaks in the loop wire of a Husqvarna AUTOMOWER 310?
If the loop wire of your Husqvarna Lawn Mower is broken, it's often due to unintentional physical damage, like accidentally cutting it while gardening, or stretching the wire too much during installation. To find the break, try halving the loop's distance where you suspect the damage. Keep halving the distance until you're left with a very short section of wire. This should help you pinpoint the location of the break.
What to do if my Husqvarna Lawn Mower is trapped?
If your Husqvarna Lawn Mower gets trapped, it might be stuck in a confined area with multiple obstacles. Inspect the area for obstructions hindering movement. Remove these obstacles or create an island around them to allow the mower to navigate freely.
Why does my Husqvarna AUTOMOWER 310 say guide not found?
If your Husqvarna Lawn Mower displays 'Guide not found', the mower is no longer receiving signals from the guide wire. Check the guide wire connection to the charging station. There may be a break in the guide wire. If the mower was used on another installation with different guide wires, this message can appear.
What to do if Husqvarna Lawn Mower is having difficult finding home?
If your Husqvarna Lawn Mower says 'Difficult finding home', the mower followed the boundary wire but didn't find the charging station. Check the boundary wire's corridor width setting and location.
What to do if Husqvarna AUTOMOWER 310 cutting system is blocked?
If your Husqvarna Lawn Mower says 'Cutting system blocked', grass or another object may be wrapped around the blade disc. Check the blade disc and remove any object. The blade disc might be in a pool of water, so move the mower and fix the water collection issue. The blade motor could be defective, so ensure it has the right speed. The main circuit board might be defective, so change it. The cabling to the blade motor could be damaged or faulty, so check and repair or replace the blade motor.
Why does my Husqvarna AUTOMOWER 310 have no loop signal?
If your Husqvarna Lawn Mower displays 'No loop signal', it could be due to several reasons. The boundary wire might be broken, or the power supply isn't connected. Also, the connection between the mower and charging station may be broken. The boundary wire could be laid incorrectly around an island, or there might be disturbances from metal objects or buried cables. The power voltage cable could be damaged or not connected, or the boundary wire isn't connected to the charging station. If ECO mode is on, place the mower in the charging station, press START, and close the hatch. Check the LED on the charging station to troubleshoot the loop signal.
General| Cutting Width | 22 cm |
|---|---|
| Cutting Height Min | 20 mm |
| Cutting Height Max | 50 mm |
| Battery Type | Li-ion |
| Typical Charging Time | 60 min |
| Typical Mowing Time per Charge | 70 min |
| Maximum Incline Within the Working Area | 40% |
| Working Area Capacity | 1000 m² |
| Battery Capacity | 2.1 Ah |
| Weight | 9.4 kg |
| Battery Voltage | 18 V |
| Operating Time | 70 min |
| Maximum Area | 1000 m² |
| Weather Resistance | Yes |
| Smart Connectivity | No |
| Blade Type | Pivoting razor blades |
To Next Page
