Husqvarna AUTOMOWER 310 - Charge a Flat Battery; Adjust the Cutting Height

24 h
A
B
Standby
Mowing
Charging
Opera
tion
Automower
®
310
Operation, A = max. hours 18
Charging/Standby, B = min. hours 6
4.7.4 Example 2
The times used in this example are applicable to
Automower
®
310, but the principle is the same for the
other models.
Timer setting Period 1 (A): 00:00 - 16:00
Timer setting Period 2 (C): 20:00 - 23:00
Active period (A): 00:00 - 16:00
Active period (C): 20:00 - 22:00
The robotic lawnmower will operate between 00:00 and
16:00. It will begin again at 20:00 but stops running at
23:00 due to standby mode until it starts again at 00:00.
Mowing
Charging
Standby
Standby
Operation
Operation
24 h
A
D
C
B
Automower
®
310
Operation, A + C = max. hours 18
Charging/Standby, B + D = min. hours 6
4.8 Charge a flat battery
When the Husqvarna robotic lawnmower is new or has
been stored for a long period, the battery will be flat and
needs to be charged before starting.
WARNING: Only charge the robotic lawnmower
using a charging station which is intended for it.
Incorrect use may result in electric shock,
overheating or leakage of corrosive liquid from
the battery.
In the event of leakage of electrolyte flush with
water and seek medical help if it comes in
contact with the eyes etc.
1. Set the main switch to position 1 .
2. Place the robotic lawnmower in the charging station.
Open the hatch and slide the robotic lawnmower in
as far as possible to ensure proper contact between
the robotic lawnmower and the charging station. See
contact and charging strips in Charging the battery
on page 12
3. The display shows a message that charging is in
progress.
4.9 Adjust the cutting height
The cutting height can be varied from MIN (2 cm) to
MAX (6 cm).
CAUTION: During the first weeks after a new
installation, the cutting height must be set to
MAX to avoid damaging the loop wire. After this,
the cutting height can be lowered step by step
every week until the desired cutting height has
been reached.
4.9.1 To adjust the cutting height
1. Press the STOP button to stop the robotic
lawnmower.
2. Open the hatch.
3. Turn the knob to the required position.
• Turn clockwise to increase the cutting height.
• Turn counter-clockwise to decrease the cutting
height.
4. Close the hatch.
840 - 001 - Operation - 45