What does a solid green light mean on my Husqvarna Automower 305 Lawn Mower charging station?
A solid green light on your Husqvarna Lawn Mower charging station indicates that everything is in order, and no action is required.
Why does my Husqvarna Automower 305 have low battery voltage?
A low battery voltage in your Husqvarna Lawn Mower can stem from a few reasons. First, ensure the mower can find the charging station by verifying that the charging station and guide wire are installed correctly. Check if the guide wire is broken or not connected by looking at the indicator light on the charging station. If the battery is spent, replace it. Also, a defective charging station antenna can cause this issue; check if the indicator light on the charging station flashes red.
Why does my Husqvarna Automower 305 Lawn Mower have no loop signal?
A 'no loop signal' error on your Husqvarna Lawn Mower can arise from several causes. First, ensure the transformer is properly connected to a working wall socket and that the miniature circuit-breaker hasn't tripped. Also, verify the low voltage cable is securely connected to the charging station. Another potential cause is that the boundary wire isn't correctly connected to the charging station. Inspect the boundary wire connector to ensure it's properly fitted. A break in the boundary wire itself could also be the reason. Locate the break, replace the damaged section with new loop wire, and splice it using an original connector. Additionally, ensure the boundary wire is laid correctly around any islands, following the instructions in the installation guide. The connection between the mow...
What to do if the slope is too steep for my Husqvarna Automower 305 Lawn Mower?
If your Husqvarna Lawn Mower stops because the slope is too steep, calibrate the tilt sensor. You can also change the boundary wire installation to exclude the steep area.
What to do if my Husqvarna Automower 305 Lawn Mower keypad is not working?
Make sure the cable between the HMI circuit board and the keypad is properly connected. You can also try replacing the keypad or the HMI circuit board.
Why is there a charging system problem with my Husqvarna Automower 305?
A charging system problem with your Husqvarna Lawn Mower can stem from a few causes. First, ensure the battery is properly connected; if not, check the battery connection. Another potential issue is using the wrong type of battery. Always use original batteries recommended by the manufacturer.
What does a blue flashing light mean on my Husqvarna Lawn Mower charging station?
A blue flashing light on your Husqvarna Lawn Mower charging station indicates that the boundary loop is not connected to the charging station or there is a break in the boundary loop. Check that the boundary wire connector is fitted properly to the charging station. If there is a break in the boundary loop, find out where the break is and replace the damaged section with a new loop wire, splicing it using an original connector.
What to do for wheel motor problem on Husqvarna Automower 305 Lawn Mower?
If you're experiencing a wheel motor problem with your Husqvarna Lawn Mower, the wheel motor itself may be defective. Check the wheel motors’ function when idling. The control box could also be defective, or the cabling to the wheel motor might be damaged.
What to do if my Husqvarna Automower 305 Lawn Mower is upside down?
Turn the Husqvarna Lawn Mower the right way up.
What to do if my Husqvarna Automower 305 is trapped?
If your Husqvarna Lawn Mower is trapped, it means the mower has gotten caught on something. Free the mower and determine what caused it to get trapped, rectifying the issue. Also, if the mower frequently gets stuck behind obstacles, check if there are any obstacles that make it hard for the mower to move.
Crucial safety guidelines for operating and maintaining the robotic lawnmower.
Guides on selecting the optimal location and securely installing the charging station.
Explains methods for laying the boundary wire and planning the working area layout.
Details the procedure for properly connecting the boundary wire to the charging station.
Covers the installation of the guide wire for improved navigation and remote area access.
Guides through initial setup, language, PIN, and automatic calibration procedures.
Procedure to confirm the mower can successfully dock with its charging station.
Step-by-step instructions for starting the robotic lawnmower.
Explains how to select operating modes like AUTO, MAN, and HOME.
Options for setting PIN codes, security levels, and managing loop signals.
Information on blade inspection, replacement, and their impact on performance.
Covers battery lifespan, replacement procedures, and care recommendations.
A detailed guide to locating and repairing breaks or faults in the boundary wire.
General| Cutting Width | 22 cm |
|---|---|
| Cutting Height Min | 20 mm |
| Cutting Height Max | 50 mm |
| Battery Type | Li-Ion |
| Typical Charging Time | 60 min |
| Sound Level Measured | 59 dB(A) |
| Area Capacity | 600 m² |
| Maximum Incline within the Working Area | 40% |
| Weight | 9.4 kg |
| Rain Sensor | Yes |
| Anti-Theft Alarm | Yes |
| Blade Type | 3 pivoting blades |
| Typical Mowing Time per Charge | 60 minutes |
| Smartphone Connectivity | Automower® Connect@Home |
To Next Page
