What causes the left wheel motor to be blocked on my Husqvarna Automower 305?
The left wheel motor of your Husqvarna Lawn Mower can become blocked if grass or another object has wrapped around the drive wheel. To resolve this, check the drive wheel and remove any obstructions.
What does a solid green light mean on my Husqvarna Automower 305 Lawn Mower charging station?
A solid green light on your Husqvarna Lawn Mower charging station indicates that everything is in order, and no action is required.
What to do if my Husqvarna Automower 305 is trapped?
If your Husqvarna Lawn Mower is trapped, it means the mower has gotten caught on something. Free the mower and determine what caused it to get trapped, rectifying the issue. Also, if the mower frequently gets stuck behind obstacles, check if there are any obstacles that make it hard for the mower to move.
What to do if there is a front loop sensor problem on my Husqvarna Automower 305?
If you're experiencing a front loop sensor problem on your Husqvarna Lawn Mower, it could be due to a faulty or loose cable to the sensor circuit board; check the cabling and refit or replace if necessary. The front loop sensor circuit board itself might be faulty, so check and replace it if needed. An electronic or software issue within the product could also be the cause; check the levels for the A signal.
Why is my Husqvarna Automower 305 Lawn Mower showing a constant red light?
A constant red light on your Husqvarna Lawn Mower indicates an error in the circuit board or an incorrect power supply in the charging station. The error must be corrected by an authorized service technician. Speak to your local Husqvarna representative.
Why is there a charging system problem with my Husqvarna Automower 305?
A charging system problem with your Husqvarna Lawn Mower can stem from a few causes. First, ensure the battery is properly connected; if not, check the battery connection. Another potential issue is using the wrong type of battery. Always use original batteries recommended by the manufacturer.
What to do if the slope is too steep for my Husqvarna Automower 305 Lawn Mower?
If your Husqvarna Lawn Mower stops because the slope is too steep, calibrate the tilt sensor. You can also change the boundary wire installation to exclude the steep area.
How to fix 'No loop signal' on a Husqvarna Automower 305?
The 'No loop signal' message on your Husqvarna Lawn Mower can appear if the boundary wire is crossed on its way to and from an island. Check that the boundary wire is laid according to instructions, ensuring it's in the correct direction around any islands. Also, disturbances from metal objects (fences, reinforcement steel) or buried cables nearby can cause this issue. Try moving the boundary wire or creating islands in the work area to boost the signal strength. Another possibility is that the mower is too far from the boundary wire. Redo the boundary wire installation to ensure all parts of the work area are a maximum of 35 m / 115 ft from the boundary wire.
What to do if my Husqvarna Automower 305 Lawn Mower has a battery problem?
If your Husqvarna Lawn Mower has a battery problem, check that the battery is properly connected. Also, ensure that you are using only original batteries recommended by the manufacturer.
How to troubleshoot low battery on Husqvarna Lawn Mower?
If you're experiencing low battery issues with your Husqvarna Lawn Mower, consider these potential causes: The product may be unable to locate the charging station, so try repositioning the guide wire. Check the installation settings related to finding the charging station. The battery itself might be spent, requiring a battery test. Also, the charging station's antenna could be defective; look for a red flashing indicator lamp and replace the baseplate if needed.
General| Cutting Width | 22 cm |
|---|---|
| Cutting Height Min | 20 mm |
| Cutting Height Max | 50 mm |
| Battery Type | Li-Ion |
| Typical Charging Time | 60 min |
| Sound Level Measured | 59 dB(A) |
| Area Capacity | 600 m² |
| Maximum Incline within the Working Area | 40% |
| Weight | 9.4 kg |
| Rain Sensor | Yes |
| Anti-Theft Alarm | Yes |
| Blade Type | 3 pivoting blades |
| Typical Mowing Time per Charge | 60 minutes |
| Smartphone Connectivity | Automower® Connect@Home |
Crucial safety guidelines for operating and maintaining the robotic lawnmower.
Guides on selecting the optimal location and securely installing the charging station.
Explains methods for laying the boundary wire and planning the working area layout.
Details the procedure for properly connecting the boundary wire to the charging station.
Covers the installation of the guide wire for improved navigation and remote area access.
Guides through initial setup, language, PIN, and automatic calibration procedures.
Procedure to confirm the mower can successfully dock with its charging station.
Step-by-step instructions for starting the robotic lawnmower.
Explains how to select operating modes like AUTO, MAN, and HOME.
Options for setting PIN codes, security levels, and managing loop signals.
Information on blade inspection, replacement, and their impact on performance.
Covers battery lifespan, replacement procedures, and care recommendations.
A detailed guide to locating and repairing breaks or faults in the boundary wire.
To Next Page
