Husqvarna Automower 320

Other manuals for Husqvarna Automower 320

Quick Guide2 pages

Questions and Answers

A
Amanda Roman MDNov 24, 2025
What to do if my Husqvarna Lawn Mower has no loop signal?
- M
  Mr. Joshua Johnson Jr.Nov 24, 2025
  If your Husqvarna Lawn Mower displays a 'No loop signal' message, there could be several reasons: * The transformer might not be connected. Ensure it's properly plugged into the wall socket and check for tripped earth-fault breakers. * The low voltage cable could be damaged or disconnected. Inspect the cable for damage and ensure it's securely connected to both the charging station and the transformer. * The boundary wire may not be correctly connected to the charging station. Verify that the boundary wire connectors are properly attached to the charging station. * A break in the boundary wire. You will need to locate and repair the break, replacing the damaged section with new wire and an original coupler. * ECO mode may be activated, and the lawnmower tried to start outside th...
J
jodicomptonAug 27, 2025
What to do if the cutting motor is blocked on my Husqvarna Automower 320 Lawn Mower?
- S
  Sheila WaltersAug 27, 2025
  If the cutting motor on your Husqvarna Lawn Mower is blocked, it is likely due to: * Grass or another object has become wrapped around the blade disc. Check the blade disc and remove any obstructions. * The blade disc is sitting in a pool of water. Move the robotic lawnmower and, if possible, prevent water from collecting in the working area.
C
Christine LloydAug 28, 2025
What to do if my Husqvarna Automower 320 gets trapped?
- G
  gravesbrandiAug 28, 2025
  If your Husqvarna Lawn Mower is trapped, it could be because: * The robotic lawnmower has got caught in something. Free the robotic lawnmower and rectify the reason for it becoming trapped. * The robotic lawnmower is stuck behind a number of obstacles. Check if there are any obstacles which make it hard for the robotic lawnmower to move on from this location.
S
Shane LawsonAug 29, 2025
What happens if I enter the wrong PIN code on my Husqvarna Automower 320?
- J
  Joshua BautistaAug 29, 2025
  If a wrong PIN code is entered on your Husqvarna Lawn Mower, note that five attempts are permitted before the keypad is blocked for five minutes. To resolve this, enter the correct PIN code. If you forget the PIN code, contact your local dealer.
M
Mrs. Mariah McmahonNov 25, 2025
Why does my Husqvarna Automower 320 go outside the working area?
- G
  gibsonstevenNov 25, 2025
  If your Husqvarna Lawn Mower is going outside the designated working area, consider these potential causes: * The boundary wire connections to the charging station might be crossed. Ensure the boundary wire is connected correctly. * The boundary wire may be too close to the edge of the working area. Verify that the boundary wire has been laid according to the instructions. * The working area may have excessive slopes near the boundary loop. Check that the boundary wire has been laid according to the instructions. * The boundary wire might be laid incorrectly around an island. Ensure the boundary wire is laid according to the instructions. * Interference from metal objects or buried cables nearby. Try moving the boundary wire. * The lawnmower might be struggling to differentiat...
R
Robert RyanSep 16, 2025
What does 'Guide calibration failed' mean on my Husqvarna Lawn Mower?
- B
  Benjamin JohnsonSep 16, 2025
  If your Husqvarna Lawn Mower displays 'Guide calibration failed', it means that the robotic lawn mower has failed to calibrate the guide wire. Check that the guide wires are installed according to the instructions.
T
Tina DennisSep 14, 2025
What to do if my Husqvarna Lawn Mower shows 'No response from charger'?
- M
  Michael JohnsonSep 14, 2025
  If your Husqvarna Lawn Mower displays 'No response from charger', it suggests communication problems between the robotic lawnmower and charging station. Remove the robotic lawnmower from the charging station and put it back again. Check that there is good contact between the charging strips on the lawnmower and the charging station.
M
Melissa FloresSep 15, 2025
What does 'Weak GPS signal' mean on my Husqvarna Automower 320?
- T
  Tara StevensonSep 15, 2025
  If your Husqvarna Lawn Mower displays 'Weak GPS signal', it means that the GPS signal is weak for the current working area and GPS assisted navigation cannot be used. If the message appears often, turn off the GPS assisted navigation and instead use the manual settings for Lawn coverage.
A
Andrew HicksSep 7, 2025
What to do if my Husqvarna Automower 320 is upside down?
- J
  jacquelinewilkinsSep 7, 2025
  If your Husqvarna Lawn Mower is upside down, it means that it is leaning too much or has turned over. Turn the robotic lawnmower the right way up.
J
Jason NielsenSep 5, 2025
Why is the cutting height blocked on my Husqvarna Lawn Mower?
- R
  Richard LeachSep 5, 2025
  If the cutting height is blocked on your Husqvarna Lawn Mower, it could be due to grass or another object wrapped around the cutting height adjustment or between the blade disc and chassis. Check the blade disc and the bellows around the cutting height adjustment, and remove any stuck debris.

Summary

Introduction and Safety

Introduction to the Automower

Overview of the robotic lawnmower, its installation, and usage instructions.

Symbols on the Robotic Lawnmower

Explanation of symbols found on the robotic lawnmower and their meanings.

Symbols in the Operators Manual

Explanation of symbols used within the Operator's Manual for clarity.

Essential Safety Instructions

Essential safety guidelines for operating, maintaining, and repairing the robotic lawnmower.

Safe Moving and Handling

Instructions for safely moving and transporting the robotic lawnmower.

Maintenance Overview

Weekly Maintenance Inspections

Steps for weekly inspection of the robotic lawnmower for wear and damage.

Presentation

Component Identification

Detailed identification and description of all parts of the robotic lawnmower and accessories.

Package Contents List

List of items included in the Automower® package for models 320 and 330X.

Product Functionality Overview

Explanation of the robotic lawnmower's mowing technique and working method.

Installation

Installation Preparations

Essential preparation steps before starting the installation of the robotic lawnmower.

Charging Station & Transformer Installation

Steps for installing the charging station and connecting the transformer.

Battery Charging Procedure

Procedure for charging the robotic lawnmower's battery before or during installation.

Boundary Wire Installation Methods

Methods for installing the boundary wire, including pegging and burying.

Working Area Boundaries

Guidelines for laying the boundary wire around different working area edges and obstacles.

Boundary Wire: Islands and Secondary Areas

Creating islands and setting up secondary areas using boundary wire.

Boundary Wire: Passages and Slopes

Recommendations for laying boundary wire in passages, on slopes, and around obstacles.

Laying and Splicing Boundary Wire

Techniques for laying, securing, and splicing the boundary wire.

Boundary Wire Towards Charging Station

Instructions for laying the boundary wire towards the charging station.

Connecting the Boundary Wire

Procedure for connecting the boundary wire ends to the charging station.

Guide Wire Installation and Placement

Guidance on laying and positioning the guide wire for optimal navigation.

Checking Installation Signals

How to interpret the charging station indicator lamp to verify installation.

First Start-up and Calibration

Initial setup, language, country, date, time, and PIN code configuration.

Test Docking Procedure

Testing the robotic lawnmower's ability to dock with the charging station.

Use

Charging a Flat Battery

Procedure for charging the robotic lawnmower's battery when new or stored.

Using the Timer Function

How to use the timer to schedule mowing times for optimal lawn care.

Starting the Robotic Lawnmower

Step-by-step instructions for starting the robotic lawnmower.

Stopping and Switching Off

How to stop the lawnmower during operation and switch it off completely.

Adjusting Cutting Height

Guide to adjusting the cutting height for optimal grass cutting.

Control Panel Overview

Operation Selection: Start Modes

Options for starting the lawnmower: Main area, Secondary area modes.

Operation Selection: Parking Modes

Options for parking the lawnmower: Park until further notice, Start again in 3 hours.

Main Switch Operation

How to use the main switch to start and stop the robotic lawnmower.

Charging Station PARK Button

Function of the PARK button on the charging station and the lawnmower.

Menu Functions Overview

Menu Structure and Function Summary

Summary of menu selections, their purpose, and setting options.

Timer Functionality

Detailed explanation of the timer function, including scheduling and overview.

Cutting Height Adjustment

Instructions on how to adjust the cutting height of the robotic lawnmower.

Security Settings

Configuration of security levels, PIN code, alarm functions, and custom settings.

Handling Messages and Faults

How to view and interpret fault, info, and reset messages.

Weather Timer Function

Automatic adjustment of mowing times based on grass growth and weather conditions.

Installation: Finding Charging Station

Settings for finding the charging station: range, overview, tests, and search methods.

Installation: Lawn Coverage Settings

Configuring remote areas: direction, distance, and frequency for optimal lawn coverage.

Installation: GPS and Advanced Settings

Advanced installation settings: GPS, corridor width, exit angles, reversing distance.

Settings: Profile Management

Managing user profiles: saving, naming, activating for multiple gardens.

ECO Mode and Spiral Cutting

Enabling ECO mode for reduced signal usage and spiral cutting for dense grass.

General Settings: Time, Language, Country, Calibration

Adjusting time, date, language, country, and cutting height calibration.

Guide Wire Calibration and Reset

Calibrating guide wires and resetting all user settings to factory defaults.

Accessories: Headlight Settings

Configuring headlight operation, luminosity, and fault flashing.

Accessories: Mower House Settings

Settings for the mower house, including collision avoidance.

Garden Examples

Installation Proposals and Settings

Examples of garden layouts with recommended installation proposals and settings.

Maintenance Overview

Winter Storage Procedures

Instructions for cleaning, charging, and storing the lawnmower and charging station for winter.

Winter Service and Checks

Recommendations for professional service and checks before winter storage.

Post-Winter Storage Checks

Checks to perform after winter storage before resuming operation.

Cleaning the Lawnmower

Detailed instructions on cleaning the robotic lawnmower, chassis, blade disc, and wheels.

Transport and Moving Safety

Guidelines for safely transporting and moving the robotic lawnmower.

Thunderstorm Precautions

Steps to protect the lawnmower from thunderstorm damage by disconnecting connections.

Replacing Blades

Step-by-step guide for replacing the mower blades and important safety warnings.

Battery Information

Details about the battery's service life and replacement.

Troubleshooting

Fault Messages and Causes

List of display messages indicating malfunctions, their causes, and actions.

Info Messages and Causes

List of informational messages, their causes, and recommended actions.

Charging Station Indicator Lamp Meanings

Interpreting the indicator lamp's status for troubleshooting.

Symptoms and Solutions

Common symptoms of unexpected behavior and troubleshooting steps.

Finding Breaks in the Loop Wire

Methods for locating breaks in the boundary loop wire and repair instructions.

Technical Data

Guarantee Terms

Environmental Information

EC Declaration of Conformity

Husqvarna Automower 320 Specifications

General

Cutting Width	22 cm
Battery Type	Li-Ion
Sound Level	58 dB(A)
Battery Voltage	18 V
Noise Level	58 dB(A)
Weather Resistance	Yes
Boundary Wire Required	Yes
Guide Wire Required	Yes
Typical Mow Time on One Charge	60 minutes
Blade Type	3 pivoting blades
Operating Time	60 minutes