Husqvarna ZIGZAG 1030 User Manual

I
Changing
the snap-on
presser
foot
.I.•
I
The presser
feet wchich
accompany
the machine
7
h'ethe form
of loose soles w.hich
are held in
place
i on th presser
foot "ankile"
b5 a spring, If you
wish
I to change
the presser
foot, turn
the hand wheel
to-
wards you until the
needle is in the highest
posi ion.C
Renmove
the presser foot
by drawing it
towards you
whlepressing
s,lightly dwwrs
I
Slide the new presser
foot over
the front edge of
Ithe
ankle bracket
as shown in the illustration.
There
•
is
a spring on the
lower end of the
ankle bracket.
Slide on thle
presser foot so
that the round trans-
iverse
pin on the presser
foot fits in to
the space be-
tw,een
the bracket and
the spring. Then
press lighth'
backwards
and dow,nwards
and the presser root
will
q=..,,
snpinto
the correct position.
I
Changing
the presser
foot
"ankle"
-
'Certain presser
feetl cannot be constructed
as loose
soles and then
the ankle bracket
must also be
ichanged
Make sure that
the needle is
in its highest
poiion, T'hen loosen
the retaining
screw w,ith your
lethand
tuse the s,crc•d
river if it is too
tight) alnd
I
remoe I le presser
foot with •our right
band.
[7

Husqvarna ZIGZAG 1030 Specifications

General

Brand	Husqvarna
Model	ZIGZAG 1030
Category	Sewing Machine
Language	English