P/N 0387152_H
2
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
PREPARATION
Be sure merchandiser has been
leveled according to the installation
instruction. Remove any remaining
shipping braces.
Carefully unpack and inspect the End
kit components. Verify that parts listed
are present and undamaged.
Prepare merchandiser to receive end
(both sides of island) as shown in Figure 1.
A. Remove bumpers, rails, packing
materials, and splashguards.
B. Remove any shelves next to the
end being installed.
C. Remove display racks and pans
next to the end being installed
(both sides of island).
D. Remove rear shelf supports next to
the end being installed (both sides
of island).
E. Remove back panels by lifting up
and out near the bottom. No tools
are necessary.
F. Remove joint molding from door
frames next to the end being
installed (both sides of island).
G. Remove alignment pin, if
installed.
H. RLNI Only: Remove screws and
interior top panel next to the
end being installed (both sides of
island).
Figure 1. Prepare Merchandiser to Receive End
C
A
H
H
RLNI Only
F
G
RLT
To Next Page
Loading...
