HUST CNC H6D-T Manual
2 - 4
the program will advance to the “Set Restart” node of the previous node for
the system to run the program of this node and the one that follows. When
setting “If to grab previous node when restarting” parameter item as “1”, ,
the system will not grab previous node after pressing “Start” key; instead,
the program will run in the direction from “Set Restart” node. )
4. Semi-Auto/Auto: When setting “If setting the program as Auto Start” of the
mechanical parameters as “1” (required), the F6 Key will display
“Semi-Auto/Auto” for the user to shift between Semi-Auto and Auto working
modes via F6 Key.
Semi-Auto: When the program reaches M02/M30, the working will end.
Auto: When the program reachesM02/M30, the working will not stop and will
start automatic cycle for processing the next Workpiece.
During running the working program, the user may shift between Semi-Auto and
Auto via F6 Key.
5. Preview Program: Select under Auto and Program Est. mode to observe the
program content.
Under Auto screen, press F8 Key to access the Preview screen, which will display
the program content for the selected program number and then press F1 for
returning to Auto screen.
6. M01 Stop: This function can be selected at all times whether under running or
stopping status.
On Auxiliary Panel, press “M01 Stop” key to select or cancel the stopping
function. When the “M01 Stop” indicator is on, it means such function is active;
otherwise, it will be cancelled. Upon activating the “M01 Stop” function, the
“M01 Command” in the program will be deemed as stopping command; however,
the “M01 Command” will become invalid if such function is not selected.
7. Node Execution: This function can be selected at all times whether under running
or stopping status.
On Auxiliary Panel, press “Node Run” key to select or cancel such function. When
the “Node Run” indicator is on, it means such function is active; otherwise, it will
be cancelled. After selecting this function, it will not run the entire program upon
each pressing of “Start” key; instead, the program on the next line will be executed
To Next Page
Loading...
Need help?
General
