HUST CNC H6D-T - Page 200

UST CC 6-T Manual
4 - 24
Format  default value: 1, unit:1ms
88. Set the maimum rpm at which the chuck can be moved
Format  default value: 1, unit: rpm
Range: 5rpm
:
A subseuent block to an M5 Spindle Stop command is M1 chuck loosen
the chuck can only be loosened until the spindle comes to a full stop.
For a lathe furnished with an automatic material dispenser, adusting this
parameter may increase the process efficiency.
89.  hether or not to enable the screen saver
Format  default value: 
Setting  , enable
Setting  1, disable
 hen screen saver is enabled, the screen automatically enters sleep mode when
the controller remains untouched for 1 minutes, for prolonging lifespan of the
screen. Pressing any key will resume the display.
90. Set the type of Chuck isc according to the actual conditions of the machine
Format  default value: 
Setting  : ydraulic Chuck isc
Setting  1: Ordinary Chuck isc
91. If to start-ais
Format  default value: 
Setting  : o start
Setting  1: Start
92. If to start Multi-function and  heel
Format  default value: 
Setting  : o start
Setting  1: Start