HUST CNC H6D-T - Page 201

4 MCM Parameter Settings
4 - 25
and  heel multiple and the selection of ais will be determined by pressing the
Multi-function and  heel multiple selection and ais selection key.
93. Retention
94. Setting of efault feed mode at start-up
Format  default value: 
Setting  , feed per revolution .
Setting  1, feed per minute .
If  is the default mode, decimal point is not allowed in the F value. If F value
.5 mm.
If  is the default mode, decimal point is allowed behind F.
95. Setting of tool support type
Format  default value: 
Setting  , rear support
Setting  1, front support
User may set according to actual tool position. See description of pair-tools for
details about front and rear tool supports.
96. Setting of type of pulse type
Format  default value: 
Setting  , pulse  direction
Setting  1, positive/negative pulse
Setting  2, A/ phase
Setting of this parameter reuires setting of servo parameters, for matching with
pulse type generated by the pulse generator.
97. Setting of acceleration/deceleration type
Format  default value: 1
Setting  , logarithm type
Setting  1, linear type