HUST CNC H6D-T - Page 203

4 MCM Parameter Settings
4 - 27
2.
end screen to a rational value, so that the linear alteration of spindle
speed meets the site reuirements.
The above operation is for providing the user with a general method. For the
substantial inverter, the user may use these parameters freely to adust the speed.
104. Setting of handwheel direction
Format  default value: 
Setting  , , .
Setting  1, -, .
Setting  4, , -.
Setting  5, -, -.
If the handwheel has a wrong direction after connecting the wires, use may alter
the direction by setting this parameter.
105. Set Spindle Count
Format  default value: 1; Ma. value: 3
Spindle 1 C-AIS Connector
Spindle 2 A-AIS Connector
Spindle 3 -AIS Connector
106. If to insert space in the displayed ode
Format  default value: 
Setting  : es
Setting  1: o
ample: In the editing program under 1 line number, the Spindle performs
respective command code:
the line number and the respective command code:
107. Ais setting for returning to OM
Format  default value: 