HUST CNC H6D-T - Page 204

UST CC 6-T Manual
4 - 2
For eample:
Setting  : very ais will not return to OM.
Setting  1: -Ais is returning to OM.
Setting  4: -Ais is returning to OM.
Setting  5: /-Ais is returning to OM.
108. Retention
109. Sensitivity of spindle RPM sensor
Format  default value: 1
The spindle feedback filter is constant when eecuting an arc cutting in the 
mode
For a setting , filter is not active. System performs a re-calculation immediately
as long as a change occurs in the number of spindle feedback pulses.
For a setting n, system performs a re-calculation only when the number of
feedback pulses eceeds n.
110. Setting for enabling detection against error follow
Format  default value: 
Setting  , disable
Setting  1, enable
For pulse type motors, this function shall be enabled to detect servo motor follow
error; however the error limit shall be set according to machine conditions.
nabling this function can effectively protect the machine against over-travel
resulting from a servo error.
111. Setting of follow error
Format  default value: 45
A Follow rror is defined as the difference between the position of the controller
command and the position of the actual servomotor feedback.
Servo follow error  setting value, an RROR 2 alarm will be issued.