HUST CNC H6D-T - Page 205

4 MCM Parameter Settings
4 - 2
112. SIO Filtration Parameter Setting
Format 
continuous time less than ms will not respond. Such parameter is mainly
used to resist the noise interference.
For the lectrical Turret or ydraulic Turret, it is preferably to set the parameter as
Turret.
113. nabling special acceleration/deceleration form
Format  default value: 
Setting  , disable
Setting  1, enable
nabling the special acceleration/deceleration form allows further enhancement in
the acceleration/deceleration efficiency based on the linear type, s-curve type and
eponential type acceleration/deceleration curves, therefore elevating the
eecution efficiency.
In case the user finds that the efficiency of the machine is not enough during the
process, he may reach his aim by disabling parameters such as “wait for spindle to
acceleration/deceleration form”.
114. Turning Corner Round Angle Connection
Format  default value: 
  Set the Servo Motor acceleration/deceleration type to CC standard mode.
256  Set the round angle connection between each ode.
115. lectrical Magaine CC elay 1ms
Format 
It is used to set the time delay reuired for locking the CC action of the
lectrical Magaine.
116. Spindle 1 Chuck 1-ay/2-ay Solenoid alve
Format  default value: 
  1-ay Solenoid alve