HUST CNC H6D-T - Page 256

HUST CNC H6D-T Manual
6 - 4
Error Code Details Causes
D Incorrect Data Address retrieved when executing ZDNC.
M
MDI command error (commend size greater than
128bytes).
08
E Size of current program segment exceeds 128bytes.
Message
The length of certain node in the program has exceeded 128 bits.
Remedy:
Check the program and make sure that each segment is within 128 characters.
Error Code Details Causes
O RS232 error OVERRUN ERROR
P RS232 error PARITY ERROR
F RS232 error FRAME ERROR
B RS232 error BREAK ERROR
10
N RS232 error OTHER ERROR
Message
Error exists in the communication signal transmitted by RS232C Port of the Controller.
Remedy:
1. Check transmission speed of controller communication port, i.e., parameter 520 of
MCM is the same value as that of PC or man-machine interface.
2. Check the communication cables between the controller and the PC or the man-
machine interface.
Error Code Details Causes
1 CHECKSUM error of program
A SUM error in the Start-up check
D Program Memory address error (DOWN MODE)
F Program Memory is full
11
U Program Memory address error (UP MODE)
Remedy:
Double-press button to enter MDI mode. Run G10 P2001 command to clear all
the program data, check the memory battery. If the controller displays battery low (BT1)
message, you need to replace the battery (data in the memory will be lost if the
controller remains OFF for more than one year).
Auto
MDI