HUST CNC H6D-T - Page 258

HUST CNC H6D-T Manual
6 - 6
Error Code Details Causes
14
X
.
.
.
.
.
C
X, Y, Z, A, B, or C-axis Hard limit (OT) .
Message
:
Axis Tool exceeds the limit of hardware travel scope.
Remedy:
Manually move the axis into its working range.
Error Code Details Causes
15 L
Servo motor returns to Origin to find GRID signal, the
distance exceeds the setting range of the parameter.
Message:
When the axis returns to the Home Position, the Servo cannot locate the GRID signal.
Remedy:
1. Adjust the Sensor position of the Home or set the Grid count in the parameters.
2. Check if the servo feedback line is interrupted.
Error Code Details Causes
16 G G10P804 Command is wrong.
Message
:
The tapping depth in the G32 Command is 0 .
Remedy:
Check the program content.