HUST CNC H6D-T - Page 260

HUST CNC H6D-T Manual
6 - 8
Error Code Details Causes
X
.
.
.
.
.
C
X, Y, Z, A, B, C- axis software OT limit.
20
N
Number of position limits set in the dynamic range of the
software exceeds 4000.
Remedy:
Check the program or re-set MCM parameters 581~586 and 601~606, the software
travel limits.
Error Code Details Causes
22 Emergency Stop (C002=1).
Remedy:
After removal of error, turn off the Emergency Stop pushbutton, followed by pressing
the RESET button.
Error Code Details Causes
24 Memory Stack error.
Remedy:
Check for repetitive use of CALL subroutine.
Error Code Details Causes
G02/G03 command error (Radius of starting point unequal
to radius of ending point).
R
Incorrect input format of R in G02/G03
No displacement in both axes of arc interpolation, or (R<0
in lathe mode).
L 2*[RAR]>[LENGTH].
25
G I, J, R not specified in G02/G03 command.
Remedy:
Check the program. Re-calculate arc intersection and verify its coordinates.