HUST CNC H6D-T Manual
6 - 10
Error Code Details Causes
E
E in G92 is not within the (1.0 100.0) range (imperial
unit).
P
P in G76 is not within the (30 90) range.
L End of cutting preset length < max. cutting depth.
D G76 (max. cutting depth) < 0.
32
C
CANPX-CANPR< CHAMX
Threading length < threading tool withdraw length.
Remedy:
Check for any error in the cyclic tapping command of the lathe.
Error Code Details Causes
4 Kxx=0 in G34.
5 Kxx=0 in G35.
6 Kxx=0 in G36.
7 Pxx<=0 or Kxx=0 in G37.
33
Execute G35, G36, or G37 in lathe mode.
Remedy:
Check for any error in K setting in commands G34~37 of the lathe.
Error Code Details Causes
B
Format of USB/SDC file is not O8001 .
Format of USB/SDC file is not O8002 .
C Format of MCM file is not O9002 .
F
Format of function key file is not O9140 .
Format of variable file is not O9004 .
L
Format of PLC file is not O9003 .
Size of PLC document exceeds upper limit.
P Input program no. exceeds 1000 (Oxxxx).
R
LENGTH OR SUM ERROR
#13245, #13246, #13247, #13248.
S
Format of SYS file is not O9100 .
Size of SYS document exceeds upper limit.
T Format of TBL file is not O9110 .
36
W Input hex file is not in XXXX,0DH format.
Remedy:
Check for incorrect data transfer format.
To Next Page
Loading...