6 Error Message
6 - 11
Error Code Details Causes
37 NC ALARM (C007=1).
Remedy:
Check external control device, remove error and RESET.
Error Code Details Causes
38 Excessive screen display time (>3000ms).
Remedy:
1. Re-transfer screen data file.
2. Consult dealer or manufacturer.
Error Code Details Causes
41
In Tool Offset mode, the command paths between 2 single
blocks are 2 parallel lines.
Message
The intersection point is lacking between two straight lines when applying the Tip
Radius Offset function (G41, G42).
Remedy:
Check and G41, G42 commands and analyze the program route and then recalculate.
Error Code Details Causes
42 OVER CUT
Message
The system is presenting overcut condition when applying the Tip Radius Offset
function (G41, G42).
Remedy:
Same as 41.
Error Code Details Causes
43 Insufficient distance between Start and End (<0.005).
Message
The distance between the starting and ending positions is less than 0.005mm when
applying the Tip Radius Offset function (G41, G42).
Remedy:
Same as 41.
To Next Page
Loading...