HUST CNC H6D-T Manual
6 - 12
Error Code Details Causes
45
C251=0, Between the single block that the radius of
circular arc compensation < 0
Message
The transitional arc of the Chamfer between straight line and arc, arc and straight line,
as well as between arcs is less than zero (0 ) when applying the Tip Radius Offset
function (G41, G42).
Remedy:
Same as 41.
Error Code Details Causes
46
In Tool Offset mode, the system fails to determine the
center-of-arc when executing an arc command.
Message
The intersection point is lacking at the turning corners between straight line and arc and
between arc and straight line when applying the Tip Radius Offset function (G41, G42).
Remedy:
Same as 41.
Error Code Details Causes
47
After establishing the Tool makeup function, there will be
not intersection point between the turning corner of arcs.
Message
The intersection point is lacking at the turning corner between arcs when applying the
Tip Radius Offset function (G41, G42).
Remedy:
Same as 41.
Error Code Details Causes
48 Radius of tool offset < 0.
Message
The Tip offset value is less than zero (0 ) when applying the Tip Radius Offset
function (G41, G42).
Remedy:
Check the G41, G42 commands, analyze the program route and reset the Tip offset
value.
To Next Page
Loading...