HUST CNC H6D-T Manual
7 - 40
536. Setting the minimum slope of the Auto Teach function
Format= . (Default= 0)
Setting range: +360.00 ~ -360.00
537. Setting the first point distance of the Auto Teach function.
Format= . (Default= 0)
538. G41 and G42 Handling type
Format= (Default 0)
When the setting value =0, an error is displayed, the interference problem
is not handelled, and the motion is stopped.
=1 Automactilly handle the interference problem.
=2 The error message is not displayed and the interference problem is
not handeled.
539. System Reserved
540. Adjustment of the feedback direction for the axes
Format= (Default 0)
Set the corresponding axes by the bit pattern.
Description:
If MCM540 1, Bit0 = 1, the feedback direction is reverse for the X-axis.
If MCM540 2, Bit1 = 1, the feedback direction is reverse for the Y-axis.
If MCM540 4, Bit2 = 1, the feedback direction is reverse for the Z-axis.
If MCM540 8, Bit3 = 1, the feedback direction is reverse for the A-axis.
If MCM540 16, Bit4 = 1, the feedback direction is reverse for the B-axis.
If MCM540 32, Bit5 = 1, the feedback direction is reverse for the C-axis.
If MCM540 64, Bit6 = 1, the feedback direction is reverse for the U-axis.
If MCM540 128, Bit7 = 1, the feedback direction is reverse for the V-axis.
If MCM540 256, Bit8 = 1, the feedback direction is reverse for the W-axis.
541. Arc type
Format= (Default 0)
Setting =0 arc cord height control.
=1 arc cord length control.
=2 system internal automatic control (500 sections/sec).
MCM# 542~560 System Reserved
To Next Page
Loading...