HUST CNC H6D-T Manual
9 - 6
Execute HCON.exe (Refer to the chapter’s section 10) to ascertain that there is no
error in the communications protocol.
Upon entering the data transmission mode ( FileSvc ) ,
(1) Select “ Recv File fm CNC : TYPE >>> ”
(2) Select 9 : Var 0 99 (Retrieve 99 variables)
Or A : Var 0 199
Or B : Var 0 299
.......
.......
Or Q : Var 0 8999
Or R : Var 0 9999 (Retrieve 9999 variables)
(3) Press “ Recv In ”
(4) Upon ascertaining the file content, press Save File to store the file name for
the file to be saved.
Caution: When the controller is running programs (where S080=1), there is a need to wait for
the program execution to stop (where S080=0) before running steps (3) & (4).
9.1.7 Transfer PLC Ladder from PC to CNC controller
Movement program:
1. The controller is not in a program execution state (where S080 = 0).
2. On the PC end, verify that the PC computer end is ready to carry out the program
transmitting movement.
Execute HCON.exe to ascertain that there is no error in the communication
protocol
Upon entering the data transmission mode ( FileSvc ),
(1) Select “Send File To CNC : TYPE >>> ”
(2) Select “ 3:PLC ” (transmitting the PLC data to the controller)
(3) Press “ Open File ” to select the PLC file to be transmitted.
(4) There is a need to check“ w2FLASH ”to execute the burn movement.
(5) Upon ascertaining the file content, press Send Out .
The computer automatically uploads the data.
Caution:
1. When the controller is running programs (where S080=1), there is a need to wait for
the program execution to stop (where S080=0) before running step (5).
2. If step (4) “w2FLASH” movement has not been executed, then after uploading the
data, there is a need to execute the MDI (G10 P600 L3) burn command, or else
when the controller turns off the power, and at the startup, the system uploads the
PLC on the Flash-ROM to the memory cache.
3. Upon completing transmitting the PLC file, make sure that the screen is prompted
with “Data Loading Ok!”, otherwise it indicates that the PLC file has not been
transmitted successfully.
To Next Page
Loading...