112479_0510 7-1
STORAGE
When storing the unit at the end of the mowing season, the following steps should be taken to ensure readiness for the next mowing
season.
1. Remove all grass, dirt, and trash from mower. Clean
mower and touch up all scrapes with Hustler
®
spray
paint.
IMPORTANT: Wash the machine with a mild detergent
and water. Do not pressure wash the machine. Avoid
excessive use of water, especially near the control panel.
2. Check thoroughly for any worn or damaged parts that
need replacing and order them from your dealer.
3. Thoroughly lubricate machine, according to lubrication
instructions.
4. Fully charge and service the batteries.
5. Block machine up so weight is off tires.
6. Do not deflate tires.
7. The mower should be stored in a well ventilated, clean
and dry place as the battery charger can not be used in a
wet environment. Connect the battery charger to the
charger port.
a. Always keep the batteries fully charged. Especially
important to prevent battery damage when the
temperature is below 32°F (0°C).
b. Attach the charger adapter to the charging port and
the batteries per the Charging Adapter section in the
Electrical System chapter.
c. Plug the charger into a proper electrical outlet. Refer
to Battery Charger, Battery Charging and Charging
Recommendations sections of the Electrical System
chapter for more details on using the charger and
charging the batteries.
d. For additional information on battery storage refer to
the Battery Storage section of the Electrical System
chapter of this manual.
New season preparation
Before starting the mower following post season storage, the
following servicing is required:
1. Clean machine, removing trash and dirt accumulation.
2. Tighten any bolts that have loosened and make sure all
hair pins, cotter pins and clevis pins are in place.
3. Install all safety shields and covers and review safety
precautions listed in this manual.
4. Check and inflate tires to 8-12 psi (55-83 KPa).
5. Attach the tractor harness to the charging port and the
batteries per the Charging Adapter section in the
Electrical System chapter.
6. Close seat pan and re-install seat pan hardware.
WARNING: Make sure seat pan is securely bolted
down prior to each use to prevent seat from moving/
tilting in the event of mower tipping or rollover.
PRODUCT LITERATURE
If you would like to view or print a copy of the Hustler
®
Zeon product manuals go online to www.hustlerturf.com and click on the
MANUALS button.
To Next Page
Loading...
Need help?
General
