HuTools HT01 - Change the Master Code

83618 137192 14710
password
Random digits
UNLOCK the door from outside


You need to enable this feature by
.


Master code User codeOr
Programming Instruct ion
How To Use
Programming Basic
LOCK the door from outside
Auto Lock Mode
The default master code is 12345678. This code must be changed
prior to programming the lock.
The Master Code is used for programming and for feature sengs.
It will also unlock the lock.
Manual Mode
A.
Master Code
A.
B.
Quick Set Up

IMPORTANT:


Please start over.
Master Code New User Code
Enter the New User Code Again
2
Add User Code
B.
Up to 20 User Codes can be stored.
Aer 10 unsuccessful aempts at entering a valid PIN code, the unit
will shut down for 3 minuets.
Wrong Entry Limit
C.
If you hear 10 beeps corresponding with 10 red flashes aer pressing
any key or lock and unlock the door, that's an indicaon that the
baeries need to be replaced soon. Please replace with 4 new AA
alkaline baeries and do not mix old and new baeries. All sengs
are retained in the memory when the baeries are removed and
replaced.

E.
Key Override can be used to gain access when the baeries are
completely dead or when no valid User Code is known.
Important Note:
Please keep at least one copy of the backup key in secure locaon
outside of your place.
Key Override
F.
User can prevent pin code exposure from strangers by entering
random digits before or aer pin code.
Unlock with Fake code
D.
a. Forward number sequence

c. Repeat number sequence
    5 6 7  9
5
679

65
If
Then
and
 965
9 65

Code is 4-10 digits.
Both master code and user code do not support the following
sequence.
Code Format
B.
Master Code New Master Code
Enter the New Code Again
1
Change Master Code
A.


3
Master Code Unwanted User Code
Delete User Code
C.
4 2
Master Code
Enable Silent Mode
D.
The beep sounds when pressing keypad can be muted. But you
will sll hear low baery and system alerts.
Disable Silent Mode
E.
4 1
Master Code
Enable Auto Lock
F.
Automacally locks the deadbolt 30 seconds aer unlocking.
This feature is off by default.
Disable Auto Lock
G.
5 2
Master Code
Vacat ion Mode
J.
This is a security feature for you when you are leaving your home
for vacaon or long trip. Enabling vacaon mode will restrict all
user codes unl master code is entered on keypad. If the lock is
unlocked by thumb turn, the lock will sound an alarm.
6
Master Code
Set Auto Lock Time Delay
H.
You can set the Auto Lock me delay between 10 and 99 seconds.
8
Master Code Enter New Duraon Time(10-99)
Add One-Time Code
I.
This code can only be used once and is automacally deleted
when used.
Enter the New User Code Again
7
Master Code New Master Code
5 1
Master Code