Hy-Gain TH3-MK3 Thunderbird - Element-to-Boom Brackets; Attaching Element Brackets

Element-to-Boom
Brackels
Select
the element-to-boom
brackets
and
insert
lhe
%"-20
xVe"
anchot screws and
1A"
nuts
as shown
in Figure
6.
ELEMENT
TO
EOOM
BRACKET
Figure 6
Lciosely assemble the larger
element-to-boom brackets
and
place
them
over one end of
the boom.
Slide
them toward
lhe boom-to-mast
bracket.
This will
be the bracket for the
Driven Element
(DE).
Loosely
assemble
the
smaller element-to-boom brackets
and
slip them over the same
end of
the
boom.
This will
be
for
the
Reflector
element.
See
Figure 7.
Loosely assemble the
remaining
pair
of element-to-boom brackets and slip them overthe
opposite end of
the
boom. This will be for the Director Element.
e
AO-O3E8-C-0t5
DO
NOT TIGHTEN
THESE
EOLTS
UIITIL
LATER
(8
REOUIREO
PER ERACKETI
IVEII
ELEIIENT ERACKET
REFLECTOR
ELETEI{T ERACKET
o
Q
to
Boot
-ro-rrAsr
BRA.KET
Figure 7
-4-
t$:
ORIVET €L€IEf,'
If,SULATOR
MVEN
ELEMENT
DETAIL
REFLECTOR-
DIRECTOR
DETAIL
l,:'<'
_l