8
System Cleaning and Preventative
Maintenance
It is recommended you perform a cleaning of the System after
each treatment.
After Each Treatment
1. Wearing gloves is recommended to avoid contact with waste material.
2. After each treatment, run the System cleaning process. To start the
process, ensure vial and tip are removed from the tubing, then take
the tubing and attach it securely to the System Cleaning Solution
cleaning cap.
(Note: Only use Rinseaway
™
or Perk System Cleaning Solution. They
are specically developed to ush through the tubing line to remove
and prevent any product or impurity build-up.)
3. Turn the vacuum to 11 for 30 seconds.
4. Empty the waste canister after each treatment. If the waste canister
is full, the System will beep and the waste canister caution light will
activate. You will not be able to perform any procedure until the waste
canister is emptied.
5. Wash, dry, and wipe/spray with Barbicide (follow manufacturer’s
instructions) over waste canister and lid. Leave open overnight
to air-dry.
To Next Page
Loading...