~7~
SPA Dermabration
Operating steps
1.Clean skin deeply.
2.Put the liquid products into the liquid bottle A, B, C or D.
3.In interface as (Fig 2) shows, Choose the function: CLEAN AND SCRUB, PEELING
SURFACE, EXTRACTION or HIDRATACIN AND PROTECTION.
4.According treated parts to choose appropriate Vacuum SPA working head. Beauticians
connect it with Vacuum SPA handle.
5.Turn [2] Function selecting knob to “Start” , press [2] confirming button, the system
begin working. if you want to pause during operation, press it again.
6.Adust Vacuum SPA pressure intensity. Press the Crystal dermabrasion cap with your
finger before adjust, and then turn [3] Vacuum adjusting knob the pressure is strong
while turning it to the clockwise, the intensity number is constantly changing. The
beautician should consider the nursing part and make sure the guests can accept the
pressure.
7.Turn [4] Water level adjusting knob to adjust water flux, the flux is big while turning it to
the counter clockwise, the intensity number is constantly changing.
8.
The system will pause automatically if the setting time is over. press any key to
continue.
10.When the cursor move to “ ”, return to interface as (Fig 2).
1.
Wastewater recycling bottle if it was full
Beautician hold the Vacuum SPA handle on skin for a while until the water flow into the
working head, and then drop some water on skin by points, to make the skin surface
wet, and move the it on skin back and forth.
9.
Do not use on wound skin.
2.Pour out the water in the waste recycling bottle in time to avoid damage caused by
overflowing.
3.Different size of working heads can be flush with water directly, then soaked with 75%
alcohol.
4.Clean the
Cautions
Cautions
4.Another Vacuum dermabrasion care must be in 30 minutes later.
1.Do not to use when there is sensitive skin, swelling, injury, inflammation.
2.Keep your skin in a good condition after treatment, use care products which are gentle
and no harm, pay more attention to sun block.
3.Do not do shaving or use scrub until three days later.
To Next Page
Loading...
