~6~
4.Set work time.
5.Accor ding treated parts to choose appropriate Vacuum
dermabrasion working heads, beauticians connect the Vacuum
dermabrasion working head with Vacuum dermabraion handle,
turn [2] Function selecting knob to “Start” , press [2] confirming
button, the system begin working. If you want to pause during
operation, press it again.
6.Turn [3] Vacuum adjusting knob to adjust dermabrasion vacuum
intensity, the pressure is strong while turning it to the clockwise,
the intensity number is constantly changing. The beautician
should consider the nursing part and make sure the guests can
accept the pressure.
.
The system will pause automatically if the setting time is over.
press any key to continue.
EXPLANATION
1.In interface as (Fig 2) shows, Choose “EXPLANTION” to enter
into interface as (Fig 8).
Step1. Cleansing and exfoliation.
By removing dead skin cells healthy new is revealed.
Step2. Superficial peeling.
The action of light peeling softens pore impurity without irritation.
Step3. Extraction.
Instantly blackheads and whiteheads are removed painlessly.
Step4. Hydration.
The skin is washed with a solution rich in antioxidants and highly moisturizing
hyaluronic acid.
Protection.
Daily use of essential commodities HydraFacial helps maintain and protect the results.
Cleaning the Wastewater recycling bottle
7 Choose the treatment area, and beautician hold the Vacuum
dermabrasion handle to move closely on skin back and forth, with
the finger moves with it.
8.
If the system appeal the prompt “The recycling bottle was full, please clean it”. please
check [8] Wastewater recycling bottle wether full, if it was full, please clean them
immediately. You could pull up buckle of Wastewater recycling bottle remove it and clean
it. You can also insert a tube into [10]Wash-out valve of wastewater recycling bottle to
make the water flowing out.
(Fig 8)
(Fig 9)
To Next Page
Loading...
