What to do if my Hydro-Pro Heat Pump shows 'Flow switch failure'?
If your Hydro-Pro Heat Pump displays a 'Flow switch failure' message, it indicates there may be insufficient water flow in the system. The causes can be no water or little water in the water system. Check the flow volume and verify the water pump is functioning correctly.
Why is there a 'High pressure protect' error on my Hydro-Pro 7024525?
A 'High pressure protect' error on your Hydro-Pro Heat Pump means the exhaust pressure is too high, triggering the high-pressure switch. You should check the high-pressure switch and cooling return circuit.
Why is there a 'Low pressure protect' error on my Hydro-Pro Heat Pump?
A 'Low pressure protect' error on your Hydro-Pro Heat Pump indicates low suction pressure, activating the low-pressure switch. Check the low-pressure switch and the cooling return circuit.
What to do if the temperature difference is too high between the water inlet and outlet of my Hydro-Pro 7024525?
If the temperature difference between the water inlet and outlet is too high on your Hydro-Pro Heat Pump, it suggests insufficient water flow. This can be caused by not enough water flow volume or a small water system pressure difference. Check the flow volume and ensure the water system isn't blocked.
What causes 'Antifreezing under cooling mode' in my Hydro-Pro 7024525 Heat Pump?
If your Hydro-Pro Heat Pump shows 'Antifreezing under cooling mode', it's likely due to insufficient water flow volume. Check the flow volume and ensure the water system is not jammed.
How to fix 'Communication failure' on Hydro-Pro 7024525 Heat Pump?
A 'Communication failure' on your Hydro-Pro Heat Pump indicates a problem between the remote wire controller and the main board. To resolve this, check the wire connection between the remote wire controller and the main board.
What to do if my Hydro-Pro Heat Pump shows 'Water inlet temp. Sensor failure'?
If your Hydro-Pro Heat Pump displays a 'Water inlet temp. Sensor failure' message, it indicates that the water inlet temperature sensor is either open or short circuit. Check or change the water inlet temperature sensor.
What to do if my Hydro-Pro 7024525 Heat Pump shows 'Water outlet temp. Sensor failure'?
If your Hydro-Pro Heat Pump displays a 'Water outlet temp. Sensor failure' message, it indicates the water outlet temperature sensor is either open or short circuit. Check or replace the water outlet temperature sensor.
What to do if my Hydro-Pro Heat Pump shows 'Ambient temp. Sensor failure'?
If your Hydro-Pro Heat Pump displays an 'Ambient temp. Sensor failure' message, it means the ambient temperature sensor is open or short circuit. You should check or change the ambient temperature sensor.
What to do if my Hydro-Pro Heat Pump shows 'Pipe temp. Sensor failure'?
If your Hydro-Pro Heat Pump displays a 'Pipe temp. Sensor failure' message, it suggests the pipe temperature sensor is open or short circuit. Check or change the pipe temperature sensor.
To Next Page
General
