What to do if my Hydro-Pro 10 shows high pressure protection?
If your Hydro-Pro Heat Pump shows a high pressure protection error, it could be due to too much refrigerant or insufficient air flow. You can discharge redundant refrigerant from the heat pump gas system or clean the air exchanger.
What to do if my Hydro-Pro 10 Heat Pump displays low pressure protection?
Low pressure protection in your Hydro-Pro Heat Pump can occur due to several reasons: not enough refrigerant, insufficient water flow, or a jammed filter or capillary. You should check for gas leaks and refill refrigerant if needed, ensure the air exchanger is clean, and replace the filter or capillary.
Why is there a large temperature difference between the inlet and outlet of my Hydro-Pro 10 Heat Pump?
If the temperature difference between the water inlet and outlet is too high in your Hydro-Pro Heat Pump, it may be due to insufficient water flow or low water pressure difference. Check the water flow volume and ensure that the water is not jammed.
What causes the cooling outlet water temperature to be too low on my Hydro-Pro 10?
If the cooling outlet water temperature is too low in your Hydro-Pro Heat Pump, the water flow volume might not be sufficient. Inspect the water flow and check if the water system is jammed.
What does it mean when the flow switch is closed on my Hydro-Pro 10 Heat Pump?
If the flow switch is closed on your Hydro-Pro Heat Pump, it could be due to low water flow, incorrect flow direction, or a faulty flow switch. Verify that the water flow is adequate and in the correct direction. If these are correct, the flow switch itself may have failed.
How does first grade antifreeze protection work on my Hydro-Pro 10?
First grade antifreeze protection in your Hydro-Pro Heat Pump during winter activates when the ambient or water inlet temperature is too low. The water pump will run automatically.
What triggers second grade antifreeze protection on my Hydro-Pro 10?
Second grade antifreeze protection in your Hydro-Pro Heat Pump during winter is triggered if the ambient or water inlet temperature is too low. The heat pump will start heating automatically.
How to fix inlet water temperature sensor failure in Hydro-Pro 10 Heat Pump?
If your Hydro-Pro Heat Pump displays an inlet water temperature sensor failure, it could be caused by an open or short circuit in the sensor. You should check or change the sensor.
What to do if the outlet water temperature sensor fails on my Hydro-Pro 10?
If you're experiencing an outlet water temperature sensor failure with your Hydro-Pro Heat Pump, the cause might be an open or short circuit in the sensor. To resolve this, check or replace the sensor.
What causes a heating condenser sensor failure in a Hydro-Pro Heat Pump?
A heating condenser sensor failure in your Hydro-Pro Heat Pump is likely due to the sensor being in an open or short circuit. The suggested solution is to check or change the sensor.
Detailed technical specifications for Hydro-Pro heat pumps across various models.
Criteria and considerations for selecting an optimal location for the heat pump.
Details on voltage, wiring, fuses, and circuit breakers for safe electrical connection.
Procedure for starting up and operating the heat pump for the first time.
Electrical wiring diagram specific to Hydro Pro 5, 7, and 10 models.
Electrical wiring diagram specific to the Hydro Pro 13 model.
Instructions on starting, stopping, setting modes, time, and temperature using the controller.
Lists error codes, their reasons, and corresponding solutions for controller issues.
To Next Page
General
