4.Use and Operation Instruction of Wire Controller
2.5 Timer setting
In the main interface，press
“
”
hold on 2 seconds and "on" is flashing, at this time,
you can set the timer on（means the unit timer is on） ，then press
“ ”
again and hold on
2 seconds and "off" is flashes you can set the timer off（means the unit timer is off）.
If you want cancel the timer off, In the "off" flashing
”
to cancel
Attention：1) If there is no operation for 5s，system will remember clock setting and back to
the main interface.
2) By pressing
" till the "off" flashing, you can set the timer off without timer on.
Flashing
Flashing
press
“
or
“
”
Press
“
”
To Next Page
