Changing the Drive Train Lubricant
Step 1: Locate the two drain plugs (Lube Drain and Lube Vent) at the top of the propeller drive
train assembly, with the propeller drive train assembly in the DOWN position.
Step 2: Use a container to catch the old lubricant.
Step 3: Place the container under the lower hole to catch the lubricant.
Step 4: Remove the drain plugs and the rudder o-rings, and rotate the propeller drive train as
shown.
Step 5: When the lubricant is fully drained, rotate the propeller drive train to its DOWN position.
Step 6: Add new lubricant.
Step 7: Wet the o-ring seals with lubricant and install. Install and tighten stainless steel drain
plug screws.
Be careful not to over-tighten the drain plugs. When the plug feels snug, turn one-
quarter turn more.
Replacement Parts & Accessory List
A Replacement Parts & Accessory List is available upon request. Please contact your local dealer.
To Next Page
Loading...