Hydrofarm PHANTOM CMH - Hanging the System; Power Up the System

HANGING THE SYSTEM
Find a suitable location for the system with sufficient cooling and distance from any heat source.
Securely install J-hooks or other appropriate means of hanging support to your grow room ceiling,
grow tent overhead support rods, or greenhouse truss.
NOTE: If installing into drywall or plaster, use wall anchors and hooks rated to hold at least 50 lbs each.
The system can be hung two different ways: VERTICALLY, using the included eye hooks; or
HORIZONTALLY, using the included wire hanger hardware.
• To hang VERTICALLY, screw the eye hooks fully into the threaded holes in the center channel
of the top of the ballast (fig. 1).
• To hang HORIZONTALLY, insert the ends of the wire hanger into the two holes built into the
side of the ballast and also use the integrated hanger (hole) on the reflector armature between
the two reflectors (fig. 2).
Using Hydrofarm item LULIFT or other reliable hanging method, suspend the system from your
overhead support.
POWER UP THE SYSTEM
1. Plug the power cord into the power input on the main panel of the ballast.
2. Plug the power cord into your power source (electrical outlet, 120/240V only).
VERTICALLY:
For overhead hanging
Using the center channel
and eye-hooks
1
1
VERTICALEMENT :
Pour une suspension
supérieure,
utiliser le canal
central et les œillets.
1
1
VERTICALMENTE:
Para colgarlo del techo
mediante ganchos sujetos
al canal central.
1
1
HORIZONTALLY:
For low profile locations
Using the wire hanger
and integrated hanger
on the reflector
armature
2
2
HORIZONTALEMENT :
Pour des lieux à profil bas ,
utiliser le câble de suspension
et le crochet intégré sur
l’armature du
réflecteur.
2
2
2
2
HORIZONTALMENTE:
Para lugares con un perfil
bajo
, utilizando el colgador de
alambre y el agujero integrado
en el armazón de los
reflectores.
7