Hydrotek 1112 User Manual

HYDROTEK® 1000 / 2000 SINGLE STATION CONTROLLER INSTALLATION /
TROUBLESHOOTING
CONTROLLER FUNCTIONS
1. TIME DIAL - Rotates one clockwise revolution every 24 hours. Controller is
programmed for automatic (AUTO)operation with the insertion of timing pins in the
time dial holes. Once properly set, correct time of day is shown by the alignment of
the arrow labeled "TIME" with the time time shown on the time dial.
2. DAY WHEEL AND RETAINED PIN ASSEMBLY - Has 14 pin locations for a 2
week program. Controller will operate in AUTO only on the days programmed by the
depression of the day wheel pin. Once properly set, correct day is shown by the
alignment of the arrow labeled "DAY" with the day shown on the wheel.
3. AUTO-OFF-ON SWITCH KNOB - Indicates the function of the controller by
turning to ON, for manual operation, AUTO, for automatic operation and OFF,to stop
manual (ON) and automatic (AUTO) functions.
4. CHASSIS SCREWS - Secures controller chassis to enclosure.
5. ELECTRICAL CONNECTION STRIP (2000 SERIES) - Allows for input and
output electrical connection. Consult Electrical Circuit and Connection Diagrams
prior to wiring.
SETTING AND OPERATION INSTRUCTIONS
z
TO SET DAY OF WEEK AND TIME OF DAY:
Turn the Day Wheel until correct day is indicated by arrowed labeled "DAY" .
Turn the Time Dial CLOCKWISE until the correct time is indicated at the arrow
labeled "TIME".
CAUTION: Set Time Dial in CLOCKWISE direction only. DO NOT FORCE TIME
DIAL IN REVERSE DIRECTION.
Pa
g
e 1 of 9
K
-Rain - H
y
drotek Controllers Instructions
8/2/2005
http://waterheatertimer.org/Woods-timers-and-manuals-old.html

Hydrotek 1112 Specifications

General

Brand	Hydrotek
Model	1112
Category	Controller
Language	English

Summary

Controller Functions

Time Dial

Rotates one revolution every 24 hours, programmed by timing pins.

Day Wheel and Retained Pin Assembly

14 pin locations for a 2-week program, set by day wheel pin.

Auto-Off-On Switch Knob

Controls manual, auto, or off operation of the controller.

Electrical Connection Strip (2000 Series)

Allows electrical connection for input and output.

Setting and Operation Instructions

Set Day of Week and Time of Day

Set day wheel and time dial clockwise to correct day and time.

Operate Manually

Turn Auto-Off-On switch to ON for manual operation.

Set Daily Operation

Program day wheel by pushing pins down for desired days.

Set Operating Times

Insert timing pins in time dial for desired operating times.

Start Automatic Operation

Turn switch to Auto after setting time/day and programming.

Electrical Connection and Safety

1000 Series Controllers Wiring

Instructions for removing face, making wire connections, and reinstalling.

2000 Series Controllers Wiring

Instructions for removing lower cover, making connections, and reinstalling.

General Cautions

Important cautions before installation or service, including power disconnect.

Wiring Diagram Models

Wiring diagrams provided for Model 2210 and Model 2214.

Troubleshooting Guide

Important Safety Note

Disconnect power before working on power or load.

Problem: Controller Fails to Keep Proper Time

Addresses issues with timekeeping, power, voltage, or drive gear.

Problem: Controller Improperly Staying ON

Troubleshoots issues with switch activation, wiring, or adjustment.

Problem: Controller Does Not Turn ON in Manual Mode

Addresses lack of power or incorrect wiring for manual operation.

Problem: Controller Fails to Operate Properly in Automatic Mode

Covers daywheel programming, switch settings, and switch adjustments.