User Guide Oxymatic Basic
Rev.Apr 2013
Hydrover Water Solutions S..L.U.
11
After settingtheOXYMATIC control unitproceed to thecable connections for other elements
of the system:
Cable Connections.-
Connection to the pH probe:
pH PROBE
Note: The OXYMATIC is pre-programmed at our factory, sound is already calibrated the the SET POINTS are
already programmed. It is highly recommended that the pH sound is not interfered with or manipulated and
that there is no modifications made to the program unless carried out by a qualified technician. Hydrover will
not take any responsibility for any modifications made by an individual that result in lack of functionality or
damage to the system. Any necessary call outs by a technician or any technical assistance necessary due to the
aforesaid will result in additional charges being made.
The pH kit includes:
pH Sensor - Buffer solutions 7 y 9
pH regulator pump. - Sensor holder
pH COMPROBATION
pH level should always remain at 7.0. If the measurement of pH is above these parameters, you must add a pH
lowering product (follow instructions for each provider) until the pH recovers to the recommended levels. If the
pH is below, add a pH increaser product (follow instructions for each provider) until the pH recovers to
recommended levels
To Next Page
Loading...