Hyperflight Blaster 2 - Parts List; Model Specifications

To Next Page

To Previous Page

HyperFlight.co.uk Blaster 2 Assembly Guide

Parts List

Wing (1 or 2 pieces).

Fuselage pod & boom.

Nosecone.

AMT - horizontal stabiliser.

Fin/rudder - vertical stab.

0.7mm carbon pushrods

and PTFE outers.

Accessories bag

containing the AMT V

mount, horns, and pushrod

parts shown opposite.

These Instructions.

R/C Functions

Left Aileron (Flaperon)

Right Aileron (Flaperon)

Elevator

Rudder

To maximise the model's potential a computer radio is highly recommended.

Suggested R/C

Wing servos: Ripmax SD100, Ripmax SD150, HyperFlight DS57

Tail servos (glider): Ripmax SD100, Ripmax SD150, HyperFlight DS57

Tail servos (electric): Ripmax SD100

Receiver: Small 4/5 channel receiver

Battery: 250-350mAh NiMH or 2S LiPo with 5V regulator

(see the alarm regulators for sale on www.hyperflight.co.uk)

Model Specifications

Wingspan: 1.5m (59 in)

Wing Area: 24 dm2 (372 sq in)

Target Weight: From 290g (10.2 oz)

Wing Loading: 12.1g/dm2 (4.0 oz/sq ft)

Airfoils: Ag 45 ct-o2, Ag46 ct-02 , AG 47 ct-02

Note these instruction are for a right handed launcher, with the launching winglet on

the left wing. For left handed launchers (with winglets on the right tip) please reverse

any left/right instructions - the rudder horn should be on the left side of the rudder.

Also please test to ensure that any cyano glue used does not melt the foam internal

structure when gluing components.